Micronics PCI/ISA System Board D6-IN Manual do Utilizador descarregar pdf (Página 32)

M6DPi System Board Manual

Chapter 3: Installing the M6DPi

Connecting the Graphics Option

The M6DPi is designed to accommodate an optional

VGA video connector and comes with a 15-pin monitor

cable. The connector pin-outs for both the 15-pin VGA

onboard connector and monitor cable connector are the

same as the standard 15-pin D-shell connector pin-outs.

The graphics option comes with 1MB of DRAM memory.

The 64-bit graphics processor provides high-speed accel-

eration in all graphic modes. It uses a full 64-bit non-

interleaved DRAM interface, which is twice the through-

put of 32-bit controllers. Full motion digital video can be

scaled up to full screen at 1024x768 resolution.

Connecting the Video Cable

1. Turn the computer system off.

2. Locate the monitor's power switch and make sure it

is turned OFF.

3. Plug the end of the video cable with the 15-pin

connector (which is larger than the other connec-

tor) into the video socket on the back of your

monitor. Then tighten the two thumbscrews on the

cable connector.

4. Plug the other end of the video cable into the video

socket on the M6DPi and tighten the thumbscrews

(see Figure 2.1).

See Chapter 5 for information on installing video device

drivers.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 80 81

Sem comentários

Micronics PCI/ISA System Board D6-IN Manual do Utilizador Página 32