Micronics PCI/ISA System Board D6-IN Manual do Utilizador descarregar pdf (Página 25)

4-2

Micronics M6Pi System Board Manual

Setup

The Setup program is used to configure the computer’s BIOS (Basic Input/

Output System). The computer’s BIOS is responsible for configuring the

system board and providing hardware information to the operating system. In

order for the computer to run properly, run the Setup procedure after first

installing the system board and whenever you make a hardware change to the

system.

After the system is turned on and goes through a memory test, the Power-Up

Screen (Figure 4-1) will appear on your monitor:

Figure 4-1 Power-Up Screen

When “Press <F2> to enter SETUP” appears at the bottom of the screen, press

the <F2> key to begin the Setup procedure. The CMOS Main Screen (Figure

4-2) should appear and the prompt should be on the time line. The Setup

procedure can only be activated during the boot sequence.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 50 51

Sem comentários

Micronics PCI/ISA System Board D6-IN Manual do Utilizador Página 25